ITEC Training & Education Center

This course three-and-a-half-day hands-on course is primarily designed for HVAC installers to assist in best practices in installing and 'commissioning' a variety of modern systems

DAY 1 – SHEET METAL FABRICATION

• Module 1: Introduction
• Module 2: Fabrication – Transitions
• Module 3: Fabrication – Return Drops

DAY 2 – ACCESSORY WIRING & DEVICE STARTUP

• Module 1: Humidifiers
• Module 2: Wet Switches / Condensate Safeties
• Module 3: UV Lights & Air Purifiers
• Module 4: Accessory Troubleshooting

DAY 3 – START-UP PROCEDURES

(Gas, AC, Heat Pump)

• Module 1: Gas-Fired Equipment Start-Up
• Module 2: Air Conditioning Start-Up
• Module 3: Heat Pump Start-Up
• Module 4: Documentation & Commissioning Forms

DAY 4 – HALF DAY: TESTING & FINAL EVALUATION

• Module 1: System Testing & Verification