A two-day course on the maintenance and use of a chainsaw with proper maintenance of your chainsaw, a long life can be had from it. Safe operation can prolong the life of you and others around you. Both the maintenance and operation therefore are of upmost importance. In this course you will learn how to keep your chainsaw in tip top condition and learn how to use it safely.

This course helps you to make better use of your chainsaw and advises on safety equipment. The course leads to N.P.T.C. assessment and certification Unit 30. The course does not include the N.P.T.C. Assessment fee.

At the end of the course participants will be able to:

State and identify the necessary personal protective equipment required, report on its condition and locate the various standard marks
State and identify required health and safety features on a chainsaw
Identify faults and defects on a chainsaw and cutting equipment, and decide which can be rectified by the operator and which requires the attention of a service engineer
Select and identify correct tools to enable maintenance to be carried out and report on their serviceability
Carry out correctly all routine maintenance in accordance with the manufacturer’s instruction book and/or the Lantra workbook
Prepare the chainsaw for use with the correct fuel/oil mix and chain lubrication
Start the chainsaw from both cold and hot in a safe manner
Carry out pre-cutting safety tests and state the procedures if the chainsaw fails these tests
State the possible hazards/risks when carrying out maintenance or operational tasks
Cross-cut timber accurately to required lengths
Assess and explain the terms ‘tension’ and ‘compression’ in timber • adopt safe procedures to remove a trapped guide bar
Handle and stack timber in a safe manner

Equipment

Please ask for a list of equipment you need to bring.

Assessments:

Lantra assessments are taken during the two days of training.
NPTC unit are taken after the course by independent assessors.
- Please note that NPTC assessment dates will be given to you at the time of booking training. Should these be changed, a surcharge will be made.

CHAINSAW - MAINTENANCE & OPERATION (2 DAYS) CS30 (CS0960) TO INCLUDE NPTC ASSESSMENT on 3rd day